ADT Security Services Home Security System Security System Manual do Utilizador descarregar pdf (Página 28)

Ð 28 Ð

TESTING THE SYSTEM

(CONTINUED)

Walk in front of any interior motion detectors (if used) and listen for three beeps. The

identification of the detector should appear on the display when it is activated. The display

will clear when no motion is detected. Note that if wireless motion detectors are used, there

is a 3-minute delay between activations. This is to conserve battery life.

To test all smoke detectors, follow the manufacturer's instructions. The identification of

each detector should appear on the display when each is activated.

If a problem is experienced with any protection point (no confirming sounds, no display),

CALL FOR SERVICE IMMEDIATELY.

When all protection points have been checked and are intact (closed), there should be no

zone identification numbers displayed on the touchpad.

When testing is completed, exit the TEST mode by continuing with step 5.

OFF

5. ÊÊÊ ÊÊÊ ÊÊÊ ÊÊÊ + ÊÊÊ1 ÊÊ EXIT TEST MODE

ÊÊÊ(Security Code) Enter your security code and press the OFF key.

If the test mode is inadvertently left active, it automatically

turns off after 4 hours.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Sem comentários

ADT Security Services Home Security System Security System Manual do Utilizador Página 28